FR-EK to K(C). FR-EK to K(C) ○Removal. (For the FR- EK to K, FR-ESK to K, FR-EW-. K to K). FR-E FR-EKND to KND. INSTRUCTION MANUAL. OUTLINE Economy, Trade and Industry) in September, applies to the K and less. : USED MITSUBISHI FR-EK-NA,FR-PA INVERTER, 5hp, v,BOXYB: Everything Else.
|Published (Last):||9 September 2006|
|PDF File Size:||1.22 Mb|
|ePub File Size:||2.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
Daily inspection must be performed to prevent any fault from occurring due to adverse influence by the operating environment, such as temperature, humidity, dust, dirt and vibration, changes in the parts with time, service life, and other factors. Indicate a control code. Earth ground Fault Detection At Start pr.
Incorrect system ff and connections can cause the inverter to operate improperly, its life to be reduced considerably, and in the worst case, the inverter to be damaged. Output frequency Parameter Factory Setting Output to indicate that the process value Upper limit output signal exceeded the upper limit value. Page Page – Retry function Pr. Corrective action Set the ambient temperature to within the specifications.
Incorrect handling might cause 3.7kk unexpected fault. Frequency At 5v 10v Input pr.
Taiwan MITSUBISHI EREQROL-E FR-EK INVERTER |
The long wiring mode can be set for the V class. Page Page – Applied motor Pr. Capacitor Life Alarm pr. If the operation mode cannot be changed, refer to page Power supply harmonics are different in generation source, frequency band and transmission path from radio frequency RF noise and leakage currents.
Output Terminal Function Selection pr. Terminal SE is common r520 the open collector output signals.
FR-EK-NA | Mitsubishi | EU Automation
The setting of this function is valid for the combined, PU, external and communication operations. Push A and B in the directions of f at the same time and remove the cover using C as supporting points. The external frequency setting signal and PU’s forward rotation, reverse rotation and stop keys are not accepted. Actual Operation Hour Meter Clear pr.
FR-E520-3.7K.Mitsubishi inverter (used)
Check for sudden load change. Motor need not be connected.
This mode is displayed only in PU f520. Fr-esc to sc-ene; fr-essc to sc-ene 38 pages. Terminal PC is common to the contact input signals. Parameter Write Disable Selection pr.
Comments to this Manuals Your Name. Refer to page 48 for selection. Electronic Thermal Relay Function pr. Machine Make sure that the machine is free of damage. Thanks for your message.
Measure the input signal level. Note that motor noise increases. I’ve had nothing but positive experience working with EU Automation.
Page – Output current detection function Pr. Ensure that the cables are connected to the correct terminals. Terminals SD and 5 are not isolated.
Those of the V class are isolated.