Buy the LGB MTS Loco Decoder II from Reynauld’s Euro Imports. Call us at Find great deals for LGB Decoder DCC MTS MTZ V2. Shop with confidence on eBay!. Hi all, Just been playing around with a It seems to work fine on analogue with both motor control and directional lighting, but won’t do a.
|Published (Last):||3 April 2015|
|PDF File Size:||8.55 Mb|
|ePub File Size:||12.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
No real issues however I am darned if I can figure out how to keep the cab light on in both forward and reverse without extra electronics. I set up an LGB universal remote with the programming head to do the factory reset. Or is it broken?
MTS Locomotive Decoder II | Märklin
Media New media New comments Search media. Should be simple enough with a couple of diodes. Same for thethe higher the rev the more it can do which includes speed steps. Tried it in a stainz chassis, and now fitted to an RhB drivin trailer.
LGB 55021, Works Analogue not DCC…
Was given it as a near new, but has not worked previously after being programmed but was hoping it was just something silly on the programming side of things. Calendar Monthly Weekly Agenda Archive. If you can’t read the address then there is something fundamentally wrong.
Dependant on which version of the you have, may be possible to activate the “hidden F2”! The loco did the shuffle so looked like it accepted the changes.
Changed it back to 3 for testing and low and behold it works. The programmer is great sat reading this out along with the decoder ID. JPG Slawman 8 Aug Hi Slawman if you wanted the cab light to be on all the time regardless of directional lights you could connect it to the track power pins brown and white at the bottom of the board assuming it is a full voltage light bulb not LED.
LGB , Works Analogue not DCC – G Scale Central
It is very important on lbb LGB decoders to read out address 7 to see the revision. Greg Elmassian Registered 30 Jan IF it is an older unit, then it won’t. Slawman Deckline 8 Aug The Massoth equivalent does not have this restriction.
Could be speed step mismatch as Dave says, or perhaps you’re trying to use “long address” 3 not “short address” 3? I don’t want to use F1 to run the cab light. Everywhere Threads This forum This thread.
What address are you using.
Thread starter Slawman Start date 8 Aug Just to nudge this thread back in to life, just by visually looking at the decoder is there a way to tell if it’s an old one or a newer version?
Media New media New comments Search media. Forums New posts Trending Search forums.
Arthur Aardvark Registered 7 Apr What command station are you using? Does anyone have any experience with this? Search Everywhere Threads This forum This thread. Dan Registered 31 May The information is from the manual.
LGB 55021 MTS Loco Decoder II
Facebook Pinterest Email Link. If we are trying to ascertain whether it is faulty, surely we must assume ‘lowest common denominator’ for the device.
Everywhere Threads This forum This thread. I have since read cv1 and found it to be Has it worked in the past.